Standard Reference Material-1721: Southern Oceanic Air. Ambient Nominal Amount of Substance Fraction for Carbon Dioxide, Methane & Nitrous Oxide. This Standard Reference Material (SRM) is a primary gas mixture for which the amount-of-substance fraction, expressed as concentration, may be related to secondary working standards. This SRM is intended for the calibration of instruments used for ambient carbon dioxide (CO2), methane (CH4) and nitrous oxide (N2O) determinations and for other applications. This data is public in the Certificate of Analysis for this material.

This Standard Reference Material (SRM) is intended for use as an analytical standard of known purity. It is intended primarily for use in the calibration and standardization of procedures for potassium (K) and chloride (Cl-) determinations employed in clinical analysis, including those using ion-selective electrodes, and for routine critical evaluation of the daily working standards used in these procedures. This lot of potassium chloride (KCl) was prepared to ensure a material of high purity and homogeneity and has been assayed after heating at 110 degrees C to 120 degrees C.

A comparison of the expanded uncertainty for certified values of iodine in food matrix CRMs. The CRMS were found by searching The European Virtual Institute for Speciation Analysis (EVISA) database using the terms "Iodine" and "Certified" in the Material category. The uncertainties are expanded uncertainties at approximately 95% confidence.

This dataset contains thermographic measurements acquired during single and multiple track scans on bare substrates and on single layers of powder. The substrates and powder are nickel alloy 625 and the experiments are performed inside a commercial laser powder bed fusion machine. There are four experiment cases: 1) a single scan track on a bare substrate, 2) a single scan track on a single hand-spread layer of powder, 3) multiple (39) scan tracks covering an area on a bare substrate, and 4) multiple (39) scan tracks solidifying a single hand-spread layer of powder.

The Additive Manufacturing Benchmark Test Series (AM-Bench) is developing a continuing series of controlled benchmark tests, in conjunction with a conference series, with two initial goals: 1) to allow modelers to test their simulations against rigorous, highly controlled additive manufacturing benchmark test data, and 2) to encourage additive manufacturing practitioners to develop novel mitigation strategies for challenging build scenarios.

These measurements were performed as part of the 2018 Additive Manufacturing Benchmark Test Series (AM-Bench), specifically supporting the melt pool geometry challenge (CHAL-AMB2018-02-MP) and cooling rate challenge (CHAL-AMB2018-02-CR).

These measurements were performed as part of the 2018 Additive Manufacturing Benchmark Test Series (AM-Bench). This dataset and the associated experiments are part of a continuing series of controlled benchmark tests, in conjunction with a conference series, with two initial goals, 1) to allow modelers of Additive Manufacturing processes to test their simulations against rigorous, highly controlled additive manufacturing benchmark test data, and 2) to encourage additive manufacturing practitioners to develop novel mitigation strategies for challenging build scenarios.

This dataset provides surface height data from nickel super alloy 625 experiment samples built through laser powder bed fusion additive manufacturing. The experiment methodically varied part position and orientation relative to the build plate and recoater blade and details of the experiment and dataset are available in a Journal of Research at NIST article.

SolidWorks Part file (CAD file) for a CoCr "lattice" structure additively manufactured in a laser bed powder fusion (LPBF) system at NIST.

This MEMS Calculator determines the following thin film properties from data taken with an optical interferometer or comparable instrument: a) residual strain from fixed-fixed beams, b) strain gradient from cantilevers, c) step heights or thicknesses from step-height test structures, and d) in-plane lengths or deflections. Then, residual stress and stress gradient calculations can be made after an optical vibrometer or comparable instrument is used to obtain Young's modulus from resonating cantilevers or fixed-fixed beams.